Da

✏️ Editing: rfc4528.txt

Network Working Group                                        K. Zeilenga
Request for Comments: 4528                           OpenLDAP Foundation
Category: Standards Track                                      June 2006

Lightweight Directory Access Protocol (LDAP)
                           Assertion Control

Status of This Memo

This document specifies an Internet standards track protocol for the
   Internet community, and requests discussion and suggestions for
   improvements.  Please refer to the current edition of the "Internet
   Official Protocol Standards" (STD 1) for the standardization state
   and status of this protocol.  Distribution of this memo is unlimited.

Abstract

This document defines the Lightweight Directory Access Protocol
   (LDAP) Assertion Control, which allows a client to specify that a
   directory operation should only be processed if an assertion applied
   to the target entry of the operation is true.  It can be used to
   construct "test and set", "test and clear", and other conditional
   operations.

Table of Contents

1. Overview ........................................................2
   2. Terminology .....................................................2
   3. The Assertion Control ...........................................2
   4. Security Considerations .........................................3
   5. IANA Considerations .............................................4
      5.1. Object Identifier ..........................................4
      5.2. LDAP Protocol Mechanism ....................................4
      5.3. LDAP Result Code ...........................................4
   6. Acknowledgements ................................................5
   7. References ......................................................5
      7.1. Normative References .......................................5
      7.2. Informative References .....................................5

Zeilenga                    Standards Track                     [Page 1]

RFC 4528                 LDAP Assertion Control                June 2006

1.  Overview

This document defines the Lightweight Directory Access Protocol
   (LDAP) [RFC4510] assertion control.  The assertion control allows the
   client to specify a condition that must be true for the operation to
   be processed normally.  Otherwise, the operation is not performed.
   For instance, the control can be used with the Modify operation
   [RFC4511] to perform atomic "test and set" and "test and clear"
   operations.

The control may be attached to any update operation to support
   conditional addition, deletion, modification, and renaming of the
   target object.  The asserted condition is evaluated as an integral
   part the operation.

The control may also be used with the search operation.  Here, the
   assertion is applied to the base object of the search before
   searching for objects that match the search scope and filter.

The control may also be used with the compare operation.  Here, it
   extends the compare operation to allow a more complex assertion.

2. Terminology

Protocol elements are described using ASN.1 [X.680] with implicit
   tags.  The term "BER-encoded" means the element is to be encoded
   using the Basic Encoding Rules [X.690] under the restrictions
   detailed in Section 5.1 of [RFC4511].

DSA stands for Directory System Agent (or server).
   DSE stands for DSA-specific Entry.

In this document, the key words "MUST", "MUST NOT", "REQUIRED",
   "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY",
   and "OPTIONAL" are to be interpreted as described in BCP 14
   [RFC2119].

3.  The Assertion Control

The assertion control is an LDAP Control [RFC4511] whose controlType
   is 1.3.6.1.1.12 and whose controlValue is a BER-encoded Filter
   [Protocol, Section 4.5.1].  The criticality may be TRUE or FALSE.
   There is no corresponding response control.

The control is appropriate for both LDAP interrogation and update
   operations [RFC4511], including Add, Compare, Delete, Modify,
   ModifyDN (rename), and Search.  It is inappropriate for Abandon,
   Bind, Unbind, and StartTLS operations.

Zeilenga                    Standards Track                     [Page 2]

RFC 4528                 LDAP Assertion Control                June 2006

When the control is attached to an LDAP request, the processing of
   the request is conditional on the evaluation of the Filter as applied
   against the target of the operation.  If the Filter evaluates to
   TRUE, then the request is processed normally.  If the Filter
   evaluates to FALSE or Undefined, then assertionFailed (122)
   resultCode is returned, and no further processing is performed.

For Add, Compare, and ModifyDN operations, the target is indicated by
   the entry field in the request.  For Modify operations, the target is
   indicated by the object field.  For Delete operations, the target is
   indicated by the DelRequest type.  For Compare operations and all
   update operations, the evaluation of the assertion MUST be performed
   as an integral part of the operation.  That is, the evaluation of the
   assertion and the normal processing of the operation SHALL be done as
   one atomic action.

For Search operations, the target is indicated by the baseObject
   field, and the evaluation is done after "finding" but before
   "searching" [RFC4511].  Hence, no entries or continuations references
   are returned if the assertion fails.

Servers implementing this technical specification SHOULD publish the
   object identifier 1.3.6.1.1.12 as a value of the 'supportedControl'
   attribute [RFC4512] in their root DSE.  A server MAY choose to
   advertise this extension only when the client is authorized to use
   it.

Other documents may specify how this control applies to other LDAP
   operations.  In doing so, they must state how the target entry is
   determined.

4.  Security Considerations

The filter may, like other components of the request, contain
   sensitive information.  When it does, this information should be
   appropriately protected.

As with any general assertion mechanism, the mechanism can be used to
   determine directory content.  Hence, this mechanism SHOULD be subject
   to appropriate access controls.

Some assertions may be very complex, requiring significant time and
   resources to evaluate.  Hence, this mechanism SHOULD be subject to
   appropriate administrative controls.

Zeilenga                    Standards Track                     [Page 3]

RFC 4528                 LDAP Assertion Control                June 2006

Security considerations for the base operations [RFC4511] extended by
   this control, as well as general LDAP security considerations
   [RFC4510], generally apply to implementation and use of this
   extension.

5.  IANA Considerations

5.1.  Object Identifier

The IANA has assigned an LDAP Object Identifier [RFC4520] to identify
   the LDAP Assertion Control defined in this document.

Subject: Request for LDAP Object Identifier Registration
       Person & email address to contact for further information:
           Kurt Zeilenga <kurt@OpenLDAP.org>
       Specification: RFC 4528
       Author/Change Controller: IESG
       Comments:
           Identifies the LDAP Assertion Control

5.2.  LDAP Protocol Mechanism

Registration of this protocol mechanism [RFC4520] is requested.

Subject: Request for LDAP Protocol Mechanism Registration
       Object Identifier: 1.3.6.1.1.12
       Description: Assertion Control
       Person & email address to contact for further information:
           Kurt Zeilenga <kurt@openldap.org>
       Usage: Control
       Specification: RFC 4528
       Author/Change Controller: IESG
       Comments: none

5.3.  LDAP Result Code

The IANA has assigned an LDAP Result Code [RFC4520] called
   'assertionFailed' (122).

Subject: LDAP Result Code Registration
       Person & email address to contact for further information:
           Kurt Zeilenga <kurt@OpenLDAP.org>
       Result Code Name: assertionFailed
       Specification: RFC 4528
       Author/Change Controller: IESG
       Comments:  none

Zeilenga                    Standards Track                     [Page 4]

RFC 4528                 LDAP Assertion Control                June 2006

6.  Acknowledgements

The assertion control concept is attributed to Morteza Ansari.

7.  References

7.1.  Normative References

[RFC2119]     Bradner, S., "Key words for use in RFCs to Indicate
                 Requirement Levels", BCP 14, RFC 2119, March 1997.

[RFC4510]     Zeilenga, K., Ed., "Lightweight Directory Access
                 Protocol (LDAP): Technical Specification Road Map", RFC
                 4510, June 2006.

[RFC4511]     Sermersheim, J., Ed., "Lightweight Directory Access
                 Protocol (LDAP): The Protocol", RFC 4511, June 2006.

[RFC4512]     Zeilenga, K., "Lightweight Directory Access Protocol
                 (LDAP): Directory Information Models", RFC 4512, June
                 2006.

[X.680]       International Telecommunication Union -
                 Telecommunication Standardization Sector, "Abstract
                 Syntax Notation One (ASN.1) - Specification of Basic
                 Notation", X.680(2002) (also ISO/IEC 8824-1:2002).

[X.690]       International Telecommunication Union -
                 Telecommunication Standardization Sector,
                 "Specification of ASN.1 encoding rules: Basic Encoding
                 Rules (BER), Canonical Encoding Rules (CER), and
                 Distinguished Encoding Rules (DER)", X.690(2002) (also
                 ISO/IEC 8825-1:2002).

7.2.  Informative References

[RFC4520]     Zeilenga, K., "Internet Assigned Numbers Authority
                 (IANA) Considerations for the Lightweight Directory
                 Access Protocol (LDAP)", BCP 64, RFC 4520, June 2006.

Author's Address

Kurt D. Zeilenga
   OpenLDAP Foundation

EMail: Kurt@OpenLDAP.org

Zeilenga                    Standards Track                     [Page 5]

RFC 4528                 LDAP Assertion Control                June 2006

Full Copyright Statement

This document is subject to the rights, licenses and restrictions
   contained in BCP 78, and except as set forth therein, the authors
   retain all their rights.

This document and the information contained herein are provided on an
   "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS
   OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET
   ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED,
   INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE
   INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
   WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

Intellectual Property

The IETF takes no position regarding the validity or scope of any
   Intellectual Property Rights or other rights that might be claimed to
   pertain to the implementation or use of the technology described in
   this document or the extent to which any license under such rights
   might or might not be available; nor does it represent that it has
   made any independent effort to identify any such rights.  Information
   on the procedures with respect to rights in RFC documents can be
   found in BCP 78 and BCP 79.

Copies of IPR disclosures made to the IETF Secretariat and any
   assurances of licenses to be made available, or the result of an
   attempt made to obtain a general license or permission for the use of
   such proprietary rights by implementers or users of this
   specification can be obtained from the IETF on-line IPR repository at
   http://www.ietf.org/ipr.

The IETF invites any interested party to bring to its attention any
   copyrights, patents or patent applications, or other proprietary
   rights that may cover technology that may be required to implement
   this standard.  Please address the information to the IETF at
   ietf-ipr@ietf.org.

Acknowledgement

Funding for the RFC Editor function is provided by the IETF
   Administrative Support Activity (IASA).

Zeilenga                    Standards Track                     [Page 6]

📁 Sid Gifari File Manager